Safety Data Sheets (SDS)
Thumbnail Filmstrip of Sporicidin MRC-80-1 Mold Resistant Coating Clear 4/1gal case Images
Sporicidin® Mold Resistant Coating is an easy-to-use, water-based permanent coating that incorporates a unique zero VOC, EPA registered antimicrobial. This creates an antimicrobial coating that prevents the growth of mold on the coating film. Developed for high moisture areas, mold resistant coatings form a dehydration finish that does not allow moisture penetration, thus preventing the growth of mold on the film. The quality of the product, along with the anti-abrasion and anti-scratch qualities, exceeds the performance requirements of the following microbiological resistant tests: ASTM D3273, D3274. Sporicidin Mold Resistant Coatings can be used on any new or existing building material before, during, or after installation for efficient mold proofing. It quickly penetrates and adheres to porous and non-porous surfaces, providing a stain-blocking anti-fungal coating that will not blister, crack, or chip and restores the integrity of damaged materials.
APPLICATION: Mix thoroughly prior to use to ensure ingredients are dispersed evenly throughout solution. Sporicidin Mold-Resistant Coating may be applied with a brush, roller or airless sprayer. When applying with airless sprayer, use medium pressure setting and a .018 spray tip. Apply when surface or air temperatures are 50ºF (10ºC) or higher. Second or multiple coats may be needed, depending upon the substrate and application method. Coverage ranges from 35 sq. ft/can to 1,000 sq.ft/gallon depending on which product is used, substrate porosity and surface smoothness.
CLEAN-UP: Clean hands and tools using warm, soapy water and rinse thoroughly.
DRYING TIME: Dries to the touch in 30 minutes at normal temperature, as stated above. Cooler temperatures or high humidity may lengthen drying time. Allow 2 hours between additional coats (if desired).